Is there any way to view waves from a single sensor?
Posted: Wed Feb 14, 2018 9:34 pm
Hi there,
I'm looking for some way that I can view Alpha from TP10 in real-time. Is there any way that I can achieve this with your app?
In settings, there is a 'Wave Types (Absolute)' section. Essentially, I was hoping that I could narrow down to a specific sensor in the section, but it only has pairs (AF8+TP10, TP9+TP10).
Do I have any options? I tried MuseLab, but it seems like the OSC payload only has 1 alpha signal, which I figure is averaged across all sensors.
If there are no options, would you consider implementing more granular control in the 'Wave Types (Absolute)' section?
I'm looking for some way that I can view Alpha from TP10 in real-time. Is there any way that I can achieve this with your app?
In settings, there is a 'Wave Types (Absolute)' section. Essentially, I was hoping that I could narrow down to a specific sensor in the section, but it only has pairs (AF8+TP10, TP9+TP10).
Do I have any options? I tried MuseLab, but it seems like the OSC payload only has 1 alpha signal, which I figure is averaged across all sensors.
If there are no options, would you consider implementing more granular control in the 'Wave Types (Absolute)' section?